CatPost Version 1.00 For WINServer
Programming by Robert Wolfe
Support BBS: Omicron Theta (telnet://net261.ath.cx)

I. Installation

        To install the program, copy the catpost.wcx file to your WINServer
        home directory.

        Next, you will want to create a configuration file for each conference
        that you want your text posted to.  The config files should be in
        the following format:

                Line 1: Conference # to be posted to.
                Line 2: Who you want the message to be from (see notes below).
                Line 3: Who you want the message to be addressed to.
                Line 4: The subject of the message.
                Line 5: The full path and filename of the ASCII file to  be
                        posted.

        Note that the contents of line 2 can read "SELF" (not case-sensitive).
        Doing this will tell CatPost to put it's own name into the To: field
        of the message.

II. Running the program

        The module was designed to be run from the command line.  A sample
        .CFG file is included along with a sample .CMD file that shows how
        the program is run.

        To run the program file the command line using wcRun, use the
        following command:

                wcrun /r catpost <config_filename>

        Make sure wcrun.wcx is in your WINServer home directory.

III. Support

        Support for the program can be found on my BBS, Omicron Theta,
        at net261.ath.cx.  Note that my board is also my development
        and testing site as well as my support and distribution site.

        For email support, I can be reached at robert.wolfe@muzzlethem.org.

        I can also be reached at Fido node 1:261/20 if you would like to
        get in touch with me via Fidonet Netmail as well.
